Integrated Circuit Packaging - Approaches

Approaches

The earliest integrated circuits were packaged in ceramic flat packs, which the military used for many years for their reliability and small size. Commercial circuit packaging quickly moved to the dual in-line package (DIP), first in ceramic and later in plastic. In the 1980s VLSI pin counts exceeded the practical limit for DIP packaging, leading to pin grid array (PGA) and leadless chip carrier (LCC) packages. Surface mount packaging appeared in the early 1980s and became popular in the late 1980s, using finer lead pitch with leads formed as either gull-wing or J-lead, as exemplified by small-outline integrated circuit — a carrier which occupies an area about 30 – 50% less than an equivalent DIP, with a typical thickness that is 70% less. This package has "gull wing" leads protruding from the two long sides and a lead spacing of 0.050 inches.

In the late 1990s, plastic quad flat pack(PQFP) and thin small-outline packages (TSOP) became the most common for high pin count devices, though PGA packages are still often used for microprocessors. Intel and AMD transitioned in the 2000s from PGA packages to land grid array (LGA) packages.

Ball grid array (BGA) packages have existed since the 1970s. Flip-chip ball grid array packages (FCBGA) developed in the 1990s allow for much higher pin count than other package types. In an FCBGA package the die is mounted upside-down (flipped) and connects to the package balls via a substrate that is similar to a printed-circuit board rather than by wires. FCBGA packages allow an array of input-output signals (called Area-I/O) to be distributed over the entire die rather than being confined to the die periphery.

Traces out of the die, through the package, and into the printed circuit board have very different electrical properties, compared to on-chip signals. They require special design techniques and need much more electric power than signals confined to the chip itself.

Stacking multiple dies in one package is called SiP, for System In Package, or three-dimensional integrated circuit. Combining multiple dies on a small substrate, often ceramic, is called an MCM, or Multi-Chip Module. The boundary between a big MCM and a small printed circuit board is sometimes blurry.