Effects of Cooling Rate
It is important that the PCBs be allowed to cool at a reasonable rate. If they are cooled too fast, then the PCB can become warped and the solder can be compromised. On the other hand if the PCB is allowed to cool too slowly, then the PCB can become brittle and some components may be damaged by heat. The PCB should be cooled by either a fine water spray or air cooled to decrease the amount of damage to the board.
Read more about this topic: Wave Soldering
Famous quotes containing the words effects of, effects, cooling and/or rate:
“The ultimate result of shielding men from the effects of folly, is to fill the world with fools.”
—Herbert Spencer (18201903)
“Each of us, even the lowliest and most insignificant among us, was uprooted from his innermost existence by the almost constant volcanic upheavals visited upon our European soil and, as one of countless human beings, I cant claim any special place for myself except that, as an Austrian, a Jew, writer, humanist and pacifist, I have always been precisely in those places where the effects of the thrusts were most violent.”
—Stefan Zweig (18811942)
“As a bathtub lined with white porcelain,
When the hot water gives out or goes tepid,
So is the slow cooling of our chivalrous passion,
O my much praised but-not-altogether-satisfactory lady.”
—Ezra Pound (18851972)
“At the rate science proceeds, rockets and missiles will one day seem like buffaloslow, endangered grazers in the black pasture of outer space.”
—Bernard Cooper (b. 1936)