Water Tank - Types

Types

Chemical contact tank of FDA and NSF polyethylene construction, allows for retention time for chemical treatment chemicals to "contact" ( chemically treat ) with product water. (black tank in foreground)

Ground water tank is made of lined carbon steel, it may receive water from a water well or from surface water allowing a large volume of water to be placed in inventory and used during peak demand cycles.

Elevated Water Tank is also known as a water tower, an elevated water tower will create pressure at the ground-level outlet of 1 psi per 2.31 feet of elevation, thus a tank elevated to 70 feet creates about 30 psi of discharge pressure. 30 psi is sufficient for most domestic and industrial requirements.

Vertical cylindrical dome top tanks may hold from fifty gallons to several million gallons. Horizontal cylindrical tanks are typically used for transport because their low-profile creates a low center of gravity helping to maintain equilibrium for the transport vehicle, trailer or truck.

A Hydro-pneumatic tank is typically a horizontal pressurized storage tank. Pressurizing this reservoir of water creates a surge free delivery of stored water into the distribution system.

By design a water tank or container should do no harm to the water. Water is susceptible to a number of ambient negative influences, including bacteria, viruses, algae, changes in pH, and accumulation of minerals, accumulated gas. The contamination can come from a variety of origins including piping, tank construction materials, animal and bird feces, mineral and gas intrusion. A correctly designed water tank works to address and mitigate these negative effects.

A safety based news article linked copper poisoning from a plastic tank. The article indicated that rainwater was collected and stored in a plastic tank and that the tank did nothing to mitigate the low Ph. The water was then brought into homes with copper piping, the copper was released by the high acid rainwater and caused poisoning in humans. It is important to note that while the plastic tank is an inert container, it has no effect on the incoming water. Good practice would be to analyze any water source periodically and treat accordingly, in this case the collected acid rain should be analyzed, and ph adjusted before being brought into a domestic water supply system.

The release of copper due to acidic water is monitored may be accomplished with a variety of technology, beginning with Ph strips and going to more sophisticated Ph monitors, indicate Ph which when acidic or caustic, some with output communication capabilities. There is no "linkage" between the plastic tank and copper poisoning, a solution to the problem is easy, monitor 'stored rainwater' with 'swimming pool strips' cheap and available at, swimming pool supply outlets. If the water is too acidic, contact state/county/local health officials to obtain advice and precise solutions and ph limits and guidelines as to what should be used to treat rainwater to be used as domestic drinking water.

Volumes of simple tank geometry may be calculated as follows. Beginning with the fact that a cubic foot contains 7.48 gallons. A rectangular shaped tank is calculated at (length) times (width) times (height) times 7.48 gallons equals volumentric content in US gallons. For a cylinder volume is calculated at Pi (3.14) times (radius squared) times (height) equals cubic feet times 7.48 gallons equals volumetric content in US gallons.

Articles and specifications for Water Tank applications and design considerations, these AWWA details are required in many states to complete a certification process to insure the quality of water being consumed.

The American Water Works Association is a reservoir of water tank knowledge; the association provides specifications for a variety of water storage tank applications as well as design. The AWWA's site provides scientific resources with which the reader will be able to develop an informed perspective on which to make decisions regarding their water tank requirements.