Swimming Pool - Covers

Covers

Swimming pool heating costs can be significantly reduced by using a pool cover. Use of a pool cover also can help reduce the amount of chemicals (chlorine, etc.) required by the pool. Outdoor pools gain heat from the sun, absorbing 75%–85% of the solar energy striking the pool surface. Though a cover decreases the total amount of solar heat absorbed by the pool, the cover eliminates heat loss due to evaporation and reduces heat loss at night through its insulating properties. Most swimming pool heat loss is through evaporation.

The heating effectiveness of a cover depends on type. A transparent bubble cover is the most effective, as it allows the largest amount of solar flux into the pool itself. Thermal bubble covers are lightweight UV stabilized floating covers designed to minimize heat loss on heated swimming pools. Typically they are only fitted in spring and fall (autumn) when the temperature difference between pool water and air temperature is greatest. They raise temperature of a pool by around 20 °Fahrenheit, or 11 °Celsius, after being on the pool for a week. Bubble covers are typically applied and removed by being rolled up on a device fitted to one side of the pool (see illustration). Covers fall apart after 4 or 5 years due to sun exposure, overheating in the sun while off the pool, and chlorine attacking the plastic. Bubble covers should be removed during super chlorination.

A vinyl cover absorbs more sunlight directly, allowing temperature to rise faster, but ultimately prevents the pool from reaching as high a temperature as a clear cover. Vinyl covers consist of a heavier material and have a longer life expectancy than bubble covers. Insulated vinyl covers are also available with a thin layer of flexible insulation sandwiched between two layers of vinyl. These covers are mandatory to be fitted to all pools in areas of Australia that have experienced drought since 2006. This is an effort to conserve water, as much water evaporates and transpires.

An alternative to a continuous sheet of pool covering is multiple floating disks which are deployed and removed disk by disk. They cover most of the surface of the pool and offer evaporation reduction similar to continuous covers. Various types are available, for example opaque (for UV resistance and possible reduced algal growth), transparent (for esthetics), heavy and solid (for wind resistance), light and inflatable (for ease of handling).

Safety covers

These covers are typically attached all winter, by hooked bungee cords or hooked springs connected to the pool deck, and are usually made in a variety of materials including coated or laminated vinyl or polypropylene mesh. They are custom designed to stop leaf debris from entering the pool but more importantly they also provide safety for animals and small children when designed and installed properly. The custom safety cover was invented in 1957 by Fred Meyer Jr. of Meyco Pool Covers when he found a dead animal in his pool. Today covers are made to meet ASTM safety barrier standards and have kept animals, people and even large vehicles out of the pool. They are not popular in warmer climates, due to the five to ten minutes it takes to fit/remove them, making them inconvenient for repeated application and removal.