Process
The process starts with a standard salt bath nitrocarburizing cycle, which produces a layer of ε iron nitride. Next, the workpiece is mechanically polished; typical polishing processes include vibratory finishing, lapping, and centerless grinding. Finally, the workpiece is re-immersed into the salt quench bath for 20 to 30 minutes, rinsed, and oil dipped. This last step optimizes the corrosion resistance by creating a 3 to 4 micrometre thick layer of iron oxide. It also gives the workpiece a black finish.
Read more about this topic: Quench Polish Quench
Famous quotes containing the word process:
“The process of writing has something infinite about it. Even though it is interrupted each night, it is one single notation.”
—Elias Canetti (b. 1905)
“At last a vision has been vouchsafed to us of our life as a whole. We see the bad with the good.... With this vision we approach new affairs. Our duty is to cleanse, to reconsider, to restore, to correct the evil without impairing the good, to purify and humanize every process of our common life, without weakening or sentimentalizing it.”
—Woodrow Wilson (1856–1924)
“... geometry became a symbol for human relations, except that it was better, because in geometry things never go bad. If certain things occur, if certain lines meet, an angle is born. You cannot fail. It’s not going to fail; it is eternal. I found in rules of mathematics a peace and a trust that I could not place in human beings. This sublimation was total and remained total. Thus, I’m able to avoid or manipulate or process pain.”
—Louise Bourgeois (b. 1911)