Entering and Exiting Protected Mode
Until the release of the 386, protected mode did not offer a direct method to switch back into real mode once protected mode was entered. IBM devised a workaround (implemented in the IBM AT) which involved resetting the CPU via the keyboard controller and saving the system registers, stack pointer and often the interrupt mask in the real-time clock chip's RAM. This allowed the BIOS to restore the CPU to a similar state and begin executing code before the reset. Later, a triple fault was used to reset the 286 CPU, which was a lot faster and cleaner than the keyboard controller method (and does not depend on IBM AT-compatible hardware, but will work on any 80286 CPU in any system). To enter protected mode, the Global Descriptor Table (GDT) must first be created with a minimum of three entries: a null descriptor, a code segment descriptor and data segment descriptor. In an IBM-compatible machine, the A20 line (21st address line) also must be enabled to allow the use of all the address lines so that the CPU can access beyond 1 megabyte of memory (Only the first 20 are allowed to be used after power-up, to guarantee compatibility with older software written for the Intel 8088-based IBM PC and PC/XT models). After performing those two steps, the PE bit must be set in the CR0 register and a far jump must be made to clear the prefetch input queue.
; set PE bit mov eax, cr0 or eax, 1 mov cr0, eax ; far jump (cs = selector of code segment) jmp cs:@pm @pm: ; Now we are in PM.With the release of the 386, protected mode could be exited by loading the segment registers with real mode values, disabling the A20 line and clearing the PE bit in the CR0 register, without the need to perform the initial setup steps required with the 286.
Read more about this topic: Protected Mode
Famous quotes containing the words entering, protected and/or mode:
“Women are quite capable of entering into a friendship with a man, but to keep it going—that takes a little physical antipathy as well.”
—Friedrich Nietzsche (1844–1900)
“U.S. international and security policy ... has as its primary goal the preservation of what we might call “the Fifth Freedom,” understood crudely but with a fair degree of accuracy as the freedom to rob, to exploit and to dominate, to undertake any course of action to ensure that existing privilege is protected and advanced.”
—Noam Chomsky (b. 1928)
“Literature exists at the same time in the modes of error and truth; it both betrays and obeys its own mode of being.”
—Paul Deman (1919–1983)