Load Testing - Car Charging System

Car Charging System

This section does not cite any references or sources.

A load test can be used to evaluate the health of a car's battery. The tester consists of a large resistor that has a resistance similar to a car's starter motor and a meter to read the battery's output voltage both in the unloaded and loaded state. When the tester is used, the battery's open circuit voltage is checked first. If the open circuit voltage is below spec (12.6 volts for a fully charged battery), the battery is charged first. After reading the battery's open circuit voltage, the load is applied. When applied, it draws approximately the same current the car's starter motor would draw during cranking. Based on the specified cold cranking amperes of the battery, if the voltage under load falls below a certain point, the battery is bad. Load tests are also used on running cars to check the output of the car's alternator.

Read more about this topic:  Load Testing

Famous quotes containing the words car, charging and/or system:

    I marched in with the men afoot; a gallant show they made as they marched up High Street to the depot. Lucy and Mother Webb remained several hours until we left. I saw them watching me as I stood on the platform at the rear of the last car as long as they could see me. Their eyes swam. I kept my emotion under control enough not to melt into tears.
    Rutherford Birchard Hayes (1822–1893)

    You must neither add anything to what I command you nor take away anything from it, but keep the commandments of the LORD your God with which I am charging you.
    Bible: Hebrew, Deuteronomy 4:2.

    Daily life is governed by an economic system in which the production and consumption of insults tends to balance out.
    Raoul Vaneigem (b. 1934)