Passive and Active-matrix
Monochrome passive-matrix LCDs were standard in most early laptops (although a few used plasma displays) and the original Nintendo Game Boy until the mid-1990s, when color active-matrix became standard on all laptops. The commercially unsuccessful Macintosh Portable (released in 1989) was one of the first to use an active-matrix display (though still monochrome).
Passive-matrix LCDs are still used today for applications less demanding than laptops and TVs. In particular, these are used on portable devices where less information content needs to be displayed, lowest power consumption (no backlight) and low cost are desired, and/or readability in direct sunlight is needed.
Displays having a passive-matrix structure are employing super-twisted nematic STN (invented by Brown Boveri Switzerland; scientific details were published) or double-layer STN (DSTN) technology (the latter of which addresses a color-shifting problem with the former), and color-STN (CSTN) in which color is added by using an internal filter.
STN LCDs have been optimized for passive-matrix addressing. They exhibit a sharper threshold of the contrast-vs-voltage characteristic than the original TN LCDs. This is important, because pixels are subjected to partial voltages even while not selected. Crosstalk between activated and non-activated pixels has to be handled properly by keeping the RMS voltage of non-activated pixels below the threshold voltage, while activated pixels are subjected to voltages above threshold. STN LCDs have to be continuously refreshed by alternating pulsed voltages of one polarity during one frame and pulses of opposite polarity during the next frame. Individual pixels are addressed by the corresponding row and column circuits. This type of display is called passive-matrix addressed, because the pixel must retain its state between refreshes without the benefit of a steady electrical charge. As the number of pixels (and, correspondingly, columns and rows) increases, this type of display becomes less feasible. Slow response times and poor contrast are typical of passive-matrix addressed LCDs with too many pixels.
New zero-power (bistable) LCDs do not require continuous refreshing. Rewriting is only required for picture information changes. Potentially, passive-matrix addressing can be used with these new devices, if their write/erase characteristics are suitable.
High-resolution color displays, such as modern LCD computer monitors and televisions, use an active-matrix structure. A matrix of thin-film transistors (TFTs) is added to the electrodes in contact with the LC layer. Each pixel has its own dedicated transistor, allowing each column line to access one pixel. When a row line is selected, all of the column lines are connected to a row of pixels and voltages corresponding to the picture information are driven onto all of the column lines. The row line is then deactivated and the next row line is selected. All of the row lines are selected in sequence during a refresh operation. Active-matrix addressed displays look brighter and sharper than passive-matrix addressed displays of the same size, and generally have quicker response times, producing much better images.
Read more about this topic: Liquid Crystal Display
Famous quotes containing the word passive:
“...if you are to gain any great amount of good from the world, you must attain a passive condition of mind. ...it is never to be forgotten that it is the rest of the world and not you that holds the great share of the world’s wealth, and that you must allow yourself to be acted upon by the world, if you would become a sharer in the gain of all the ages to your own infinite advantage.”
—Anna C. Brackett (1836–1911)