Line Printer - Paper (forms) Handling

Paper (forms) Handling

All line printers used Continuous form paper provided in boxes of continuous fan-fold forms rather than cut-sheets. The paper was usually perforated to tear into cut sheets if desired and was commonly printed with alternating white and light-green areas, allowing the reader to easily follow a line of text across the page. This was the iconic "green bar" form that dominated the early computer age. Pre-printed forms were also commonly used (for printing cheques, invoices, etc.). A common task for the system operator was to change from one paper form to another as one print job completed and another was to begin. Some lineprinters had covers that opened automatically when the printer required attention.

Standard "green bar" page sizes included portrait-format pages of 8½ × 11 inches, usually printed at 80 columns by 66 lines (at 6 lines per inch) or 88 lines (at 8 LPI), and landscape-format pages of 14 × 11 inches, usually printed at 132 columns by 66 or 88 lines. Also common were landscape-format pages of 14 × 8½ inches, allowing for 132 columns by 66 lines (at 8 LPI) on a more compact page.

These continuous forms were advanced through the printer by means of tractors (sprockets or sprocket belts). Depending on the sophistication of the printer, there might simply be two tractors at the top of the printer (pulling the paper) or tractors at the top and bottom (thereby maintaining paper tension within the printer). The horizontal position of the tractors was usually adjustable to accommodate different forms. The earliest printers by IBM used a hydraulic motor to move the forms. In later line printers, High-speed servomechanisms usually drove the tractors, allowing very rapid positioning of the paper, both for advancing line-by-line and slewing to the top of the next form. The faster line printers, of necessity, also used "stackers" to re-fold and stack the fan-fold forms as they emerged from the printer.

The high-speed motion of the paper often developed large electrostatic charges. Line printers frequently used a variety of discharge brushes and active (corona discharge-based) static eliminators to discharge these accumulated charges.

Many printers supported ASA carriage control characters which provided a limited degree of control over the paper, by specifying how far to advance the paper between printed lines. Various means of providing vertical tabulation were provided, ranging from a paper carriage control tape loop to fully electronic (software-controllable) tab simulation.