Uses
For many people, the most commonly encountered ISM device is the home microwave oven operating at 2.45 GHz. However, in recent years these bands have also been shared with license-free error-tolerant communications applications such as wireless sensor networks in the 915 MHz and 2.450 GHz bands, as well as wireless LANs and cordless phones in the 915 MHz, 2.450 GHz, and 5.800 GHz bands. Because unlicensed devices already are required to be tolerant of ISM emissions in these bands, unlicensed low power uses are generally able to operate in these bands without causing problems for ISM users; ISM equipment does not necessarily include a radio receiver in the ISM band (a microwave oven does not have a receiver).
In the United States, according to 47 CFR Part 15.5, low power communication devices must accept interference from licensed users of that frequency band, and the Part 15 device must not cause interference to licensed users. Note that the 915 MHz band should not be used in countries outside Region 2, except those that specifically allow it, such as Australia and Israel, especially those that use the GSM-900 band for cellphones. The ISM bands are also widely used for Radio-frequency identification (RFID) applications with the most commonly used band being the 13.56 MHz band used by systems compliant with ISO/IEC 14443 including those used by biometric passports and contactless smart cards.
In Europe, the use of the ISM band is covered by Short Range Device regulations issued by European Commission, based on technical recommendations by CEPT and standards by ETSI. In most of Europe, LPD433 band is allowed for license-free voice communication in addition to PMR446.
Wireless LAN devices use wavebands as follows:
- Bluetooth 2450 MHz band
- HIPERLAN 5800 MHz band
- IEEE 802.11/WiFi 2450 MHz and 5800 MHz bands
IEEE 802.15.4, ZigBee and other personal area networks may use the 915 MHz and 2450 MHz ISM bands.
Wireless LANs and cordless phones can also use frequency bands other than the bands shared with ISM, but such uses require approval on a country by country basis. DECT phones use allocated spectrum outside the ISM bands that differs in Europe and North America. Ultra-wideband LANs require more spectrum than the ISM bands can provide, so the relevant standards such as IEEE 802.15.4a are designed to make use of spectrum outside the ISM bands. Despite the fact that these additional bands are outside the official ITU-R ISM bands, because they are used for the same types of low power personal communications, these additional frequency bands are sometimes incorrectly referred to as ISM bands as well.
Also note that several brands of radio control equipment use the 2.4 GHz band range for low power remote control of toys, from gas powered cars to miniature aircraft.
Worldwide Digital Cordless Telecommunications or WDCT is an ISM band technology that uses the 2.4 GHz radio spectrum.
Read more about this topic: ISM Band