Active and Passive State
A destination in the topology table can be marked either as Passive or Active. A Passive state is a state when the router has identified the successor(s) for the destination. The destination changes to Active state when current successor no longer satisfies the Feasibility Condition and there are no feasible successors identified for that destination (i.e. no backup routes are available). The destination changes back from Active to Passive when the router received replies to all queries it has sent to its neighbors. Notice that if a successor stops satisfying the Feasibility Condition but there is at least one feasible successor available, the router will promote a feasible successor with the lowest total distance (the distance as reported by the feasible successor plus the cost of the link to this neighbor) to a new successor and the destination remains in the Passive state.
Read more about this topic: Enhanced Interior Gateway Routing Protocol
Famous quotes containing the words active and/or state:
“Things happen to us, all the time. It was like that for a century, and it is again. It’s not like here: People always do things, because you are born with it; you are brought up in this spirit, the active approach to life: “Stand up and go.” We were not. We were always passive in our lives.”
—Natasha Dudinska (b. c. 1967)
“The almost unexplored Everglades lay close by and with a half- hour’s start a man who knew the country was safe from pursuit. As one man cheerfully confided ..., ‘A boat don’t leave no trail, stranger.’”
—For the State of Florida, U.S. public relief program (1935-1943)