Design and Development
The DC-3 was the culmination of a development effort that originated out of an inquiry from Transcontinental and Western Airlines (TWA) to Donald Douglas. TWA's rival in transcontinental air service, United Airlines, was inaugurating service with the Boeing 247 and Boeing refused to sell any 247s to other airlines until United's order for 60 aircraft had been filled. TWA asked Douglas to design and build an aircraft that would enable TWA to compete with United. Douglas' resulting design, the 1933 DC-1, was promising, and led to the DC-2 in 1934. While the DC-2 was a success, there was still room for improvement.
The DC-3 was the result of a marathon telephone call from American Airlines CEO C. R. Smith to Donald Douglas, during which Smith persuaded a reluctant Douglas to design a sleeper aircraft based on the DC-2 to replace American's Curtiss Condor II biplanes. Douglas agreed to go ahead with development only after Smith informed him of American's intention to purchase twenty aircraft. The new aircraft was engineered by a team led by chief engineer Arthur E. Raymond over the next two years, and the prototype DST (for Douglas Sleeper Transport) first flew on December 17, 1935 (the 32nd anniversary of the Wright Brothers' flight at Kitty Hawk, North Carolina). A version with 21 passenger seats instead of the sleeping berths of the DST was also designed and given the designation DC-3. There was no prototype DC-3; the first DC-3 built followed seven DSTs off the production line and was delivered to American.
The amenities of the DC-3 and DST popularized air travel in the United States. With only three refueling stops, eastbound transcontinental flights crossing the U.S. in approximately 15 hours became possible. Westbound trips took 171⁄2 hours due to prevailing headwinds—still a significant improvement over the competing Boeing 247. During an earlier era, such a trip would entail short hops in slower and shorter-range aircraft during the day, coupled with train travel overnight.
A variety of radial engines were available for the DC-3 throughout the course of its development. Early-production civilian aircraft used Wright R-1820 Cyclone 9s, but later aircraft (and most military versions) used the Pratt & Whitney R-1830 Twin Wasp which offered better high-altitude and single engine performance. Three DC-3S Super DC-3s with Pratt & Whitney R-2000 Twin Wasps were built in the late 1940s.
Read more about this topic: Douglas DC-3
Famous quotes containing the words design and/or development:
“I begin with a design for a hearse.
For Christ’s sake not black—
nor white either—and not polished!
Let it be weathered—like a farm wagon—”
—William Carlos Williams (1883–1963)
“I hope I may claim in the present work to have made it probable that the laws of arithmetic are analytic judgments and consequently a priori. Arithmetic thus becomes simply a development of logic, and every proposition of arithmetic a law of logic, albeit a derivative one. To apply arithmetic in the physical sciences is to bring logic to bear on observed facts; calculation becomes deduction.”
—Gottlob Frege (1848–1925)