How Dolby Noise Reduction Works
Dolby noise reduction is a form of dynamic preemphasis employed during recording, plus a form of dynamic deemphasis used during playback, that work in tandem to improve the signal-to-noise ratio. While Dolby A operates across the whole spectrum, the other systems specifically emphasize the audible frequency range where background tape hiss, an artifact of the recording process that is similar to white noise, is most noticeable (usually above 1 kHz).
The Dolby preemphasis boosts the recorded level of the quieter audio signal at these higher frequencies during recording, effectively compressing the dynamic range of that portion of the signal, so that quieter sounds above 1 kHz receive a proportionally greater boost. As the tape is recorded, the relative amplitude of the signal above 1 kHz is used to determine how much pre-emphasis to apply - a low-level signal is boosted by 10 dB (Dolby B) or 20 dB (Dolby C). As the signal rises in amplitude, less and less pre-emphasis is applied until at the "Dolby level" (+3 VU), no signal modification is performed.
The sound is thus recorded at a higher overall level on the tape relative to the tape's overall noise level, requiring the tape formulation to preserve this specially recorded signal without distortion. On playback, the opposite process is applied (deemphasis), based on the relative signal component above 1 kHz. Thus as this portion of the signal decreases in amplitude, the higher frequencies are progressively more sharply attenuated, which also filters out the constant background noise on the tape when and where it would be most noticeable.
The two (pre and de-emphasis) processes are intended to cancel each other out as far as the actual recorded program is concerned. Only de-emphasis is applied to the incoming signal and noise during playback. After playback de-emphasis is complete, apparent noise in the output signal is reduced, and this process should not produce any effect noticeable to the listener. Playback without noise reduction produces a noticeably brighter sound, however.
The calibration of the recording and playback circuitry is therefore critical for faithful reproduction of the original program content, and this is easily offset by poor quality tape, dirty recording/playback heads, or using inappropriate bias levels/frequency for the tape formulation, as well as tape speed, when recording or duplicating. This can manifest itself as muffled-sounding playback, or "breathing" of the noise level as the signal varies.
On some high end consumer equipment, Dolby calibration control is included: for recording, a reference tone at Dolby level may be recorded for accurate playback level calibration on another transport; at playback, the same recorded tone should produce the identical output, as indicated by a Dolby logo marking at +3 VU on the VU meter(s). For accurate off-the-tape monitoring during recording on 3-head decks, both processes must be employed at once, and circuitry provided to accomplish this is marketed under the rubric "Double Dolby".
Read more about this topic: Dolby Noise-reduction System
Famous quotes containing the words noise, reduction and/or works:
“The noise of battle hurtled in the air,
Horses did neigh, and dying men did groan,
And ghosts did shriek and squeal about the streets.”
—William Shakespeare (1564–1616)
“The reduction of nuclear arsenals and the removal of the threat of worldwide nuclear destruction is a measure, in my judgment, of the power and strength of a great nation.”
—Jimmy Carter (James Earl Carter, Jr.)
“Your hooves have stamped at the black margin of the wood,
Even where horrible green parrots call and swing.
My works are all stamped down into the sultry mud.”
—William Butler Yeats (1865–1939)