Description
In the first design of the Altair, the parts needed to make a complete machine would not fit on a single motherboard, and the machine consisted of four boards stacked on top of each other with stand-offs. Another problem facing Roberts was that the parts needed to make a truly useful computer weren't available, or wouldn't be designed in time for the January launch date. So during the construction of the second model, he decided to build most of the machine on removable cards, reducing the motherboard to nothing more than an interconnect between the cards, a backplane. The basic machine consisted of five cards, including the CPU on one and memory on another. He then looked for a cheap source of connectors, and came across a supply of 100-pin edge connectors. The S-100 bus was eventually acknowledged by the professional computer community and adopted as the IEEE-696 computer bus standard.
The Altair bus consists of the pins of the Intel 8080 run out onto the backplane. No particular level of thought went into the design, which led to such disasters as shorting from various power lines of differing voltages being located next to each other. Another oddity was that the system included two unidirectional 8-bit data buses, but only a single bidirectional 16-bit address bus. A deal on power supplies led to the use of +8V and +18V, which had to be locally regulated on the cards to TTL (+5V) or RS-232 (+12V) standard voltage levels.
The Altair shipped in a two-piece case. The backplane and power supply were mounted on a base plate, along with the front and rear of the box. The "lid" was shaped like a C, forming the top, left and right sides of the box. The front panel, which was inspired by the Data General Nova minicomputer, included a large number of toggle switches to feed binary data directly into the memory of the machine, and a number of red LEDs to read those values back out.
Programming the Altair was an extremely tedious process. The user toggled the switches to positions corresponding to an 8080 microprocessor instruction or opcode in binary, then used an 'enter' switch to load the code into the machine's memory, and then repeated this step until all the opcodes of a presumably complete and correct program were in place. When the machine first shipped the switches and lights were the only interface, and all one could do with the machine was make programs to make the lights blink. Nevertheless, many were sold in this form. Roberts was already hard at work on additional cards, including a paper tape reader for storage, additional RAM cards, and a RS-232 interface to connect to a proper Teletype terminal.
Read more about this topic: Altair 8800
Famous quotes containing the word description:
“I was here first introduced to Joe.... He was a good-looking Indian, twenty-four years old, apparently of unmixed blood, short and stout, with a broad face and reddish complexion, and eyes, methinks, narrower and more turned up at the outer corners than ours, answering to the description of his race. Besides his underclothing, he wore a red flannel shirt, woolen pants, and a black Kossuth hat, the ordinary dress of the lumberman, and, to a considerable extent, of the Penobscot Indian.”
—Henry David Thoreau (1817–1862)
“Why does philosophy use concepts and why does faith use symbols if both try to express the same ultimate? The answer, of course, is that the relation to the ultimate is not the same in each case. The philosophical relation is in principle a detached description of the basic structure in which the ultimate manifests itself. The relation of faith is in principle an involved expression of concern about the meaning of the ultimate for the faithful.”
—Paul Tillich (1886–1965)
“The type of fig leaf which each culture employs to cover its social taboos offers a twofold description of its morality. It reveals that certain unacknowledged behavior exists and it suggests the form that such behavior takes.”
—Freda Adler (b. 1934)