Performance
Airsoft guns shoot plastic pellets at velocities from 30 m/s (98 ft/s) for a low-end spring pistol, to 200 m/s (660 ft/s) for heavily upgraded customized sniper rifles. Most non-upgraded AEGs are in the middle, producing velocities from 90 m/s (300 ft/s) to 120 m/s (390 ft/s). The internal components of most guns can be upgraded which can increase the pellet velocity significantly. Using heavier pellets (.25 g, .3 g, etc.) will significantly reduce the gun's muzzle velocity, but can increase accuracy at range and reduce susceptibility to wind drift. Lighter pellets have less kinetic energy than their heavier pellets, despite their higher exit velocity. Decreasing the pellet's weight does not generally increase its range. High-velocity AEGs often employ heavier pellets. Most high-end AEGs, such as Classic Army and Tokyo Marui, should not be loaded with anything lighter than 0.2 g pellets, as the lighter pellets (0.12 g, 0.15 g) are typically made for low-end guns, and are not built to the same quality (such as surface smoothness). The stresses the pellets go under upon firing could shatter lighter or poorly made pellets as they leave the barrel, potentially damaging the weapon.
Airsoft guns can be modified to increase pellet velocity, rate of fire, reliability, or accuracy/range. For an electric airsoft gun, the pellet velocity can be increased by two different methods. The first is upgrading the inner barrel of the gun. The inner barrel is what the BB travels within while in the gun. Stock AEG inner barrels are usually between 6.05-6.10mm. An airsoft inner barrel is considered "tight-bore" when the inner diameter is less than 6.05mm. Typically, tight-bore barrels that are 6.03mm in diameter are installed into stock AEGs, so that accuracy as well as an up to 30fps increase is enjoyed by the player. Tighter bores risk a higher chance of pellet jams and a need for higher quality pellets and require more lubrication as well as a larger cylinder inside the gear-box in some cases(to contain more air to be forced through, most commonly called a "bore-up" upgrade). Tight-bore barrel upgrades as small as 6.01mm are usually reserved for high-powered sniper rifles. The second is simply upgrading the mainspring. Doing this will increase the air pressure subjected to the pellet produced during operation. But due to the higher forces at play, it is advised that other parts should be upgraded together with the mainspring in order to maintain a high level of reliability. The rate of fire is increased by using a battery with a higher voltage, high-speed ratio gears and/or a high-speed motor. Rates of fire can be increased to over 20 rounds per second with very few upgrades, but with careful selection and extreme modification of gearbox components, rates of fire in excess of 50 rounds per second are not unheard of. In the case of gas guns, a higher pellet velocity can be achieved through the use of different types of gases and/or changing the valve. Some gases have detrimental effects to some plastic components inside the airsoft gun.
The ballistics of spring or electric powered airsoft guns differ from real firearms in that a longer barrel will not always result in better accuracy. In spring/electric airsoft weapons, barrel length does not have a significant effect on accuracy. The "sweet spot" for barrel length in a spring/electric powered airsoft gun is around 400-500mm. Past that length, added barrel length will not improve accuracy. In any case, barrel quality, fps consistency, and hopup quality/design are more important factors in regard to accuracy. However, added barrel length will result in slightly increased velocity if the cylinder size and compression are appropriate for the barrel length. For example, a gun with a large cylinder and a long barrel will shoot slightly harder than a gun with a small cylinder and a short barrel(with everything else being equal). This rule will apply even for barrels longer than 500mm, if there is enough cylinder volume and air compression to propel the BB through the barrel. However, the resulting FPS increase will be hardly noticeable. The only considerable advantage of using a longer inner barrel in an aeg or spring powered gun is that it generally will make the gun quieter. Gas powered replicas function more like real firearms. In gas powered guns, added barrel length (to an appropriate degree) will result in significantly increased velocity, and increased accuracy to a degree.
Another common upgrade done my most players is in the "Hop-Up" system. Most mid to high end AEG's, as well as gas guns and spring sniper rifles, feature this "hop-up" system, in which the wall of a rubber tube, called a bucking, is forced into the path of the pellet right before it begins flying down the inner barrel, causing it to begin spinning backwards, giving it a straight shot upward as soon as it leaves the barrel. This is adjusted by screws or gears that cause the bucking to only show a small or large presence in the barrel. Different degrees of firmness of the rubber are considered when a hop-up is being upgraded. The hop-up can either make or break an airsoft gun's range and accuracy: Too much hop-up makes the pellet fly very straight, but also makes it take a sharp curve upward as soon as it leaves the barrel. Too little hop-up and the pellet won't necessarily fly upwards, but in whatever direction the air resistance lets it. The hop-up is adjusted around the weight of the pellet and the speed in which it is leaving the barrel. A well-tuned hop-up puts just enough spin on the pellet as to it flies straight, but not too much so that it can fly for a distance of 140–300 ft before curving upwards.
Airsoft guns commonly come with mounts or rails on which the airsofter can add external accessories. Some common customizations added are flashlights, scopes and lasers. Since some airsoft guns have the exact external frame as real guns, one can use these external parts meant for real guns, but the opposite does not apply. Airsoft replicas of real scopes are commonly made available for sale at a much lower price (sometimes thousands of dollars less). The replicas differ from their real-steel counterparts in that the replicas are not made to function in a high-recoil environment such as that in a real gun. In no way can an airsoft rifle be modified to shoot real ammunition. In most cases, add-ons are more for aesthetics rather than performance. However, scopes can commonly increase accuracy at longer ranges and can also allow for quicker aiming on large airsoft guns, with proper firing technique by the user/operator (the installation of a scope does not physically make the gun fire pellets more accurately). Other attachments, such as replica grenade launchers can act as under-barrel shotguns (in lower-end models), and a mock silencer can be added to provide concealment for a longer inner barrel therefore improving accuracy and range.
Read more about this topic: Airsoft Guns
Famous quotes containing the word performance:
“Just as the performance of the vilest and most wicked deeds requires spirit and talent, so even the greatest demand a certain insensitivity which under other circumstances we would call stupidity.”
—G.C. (Georg Christoph)
“Nobody can misunderstand a boy like his own mother.... Mothers at present can bring children into the world, but this performance is apt to mark the end of their capacities. They cant even attend to the elementary animal requirements of their offspring. It is quite surprising how many children survive in spite of their mothers.”
—Norman Douglas (18681952)